LEDTask™ Flexible LED Tape Installation Guide
Before You Begin
1.
Install all drivers and tape in accordance with
national and local electrical codes and building
standards.
2.
In all cases, GM Lighting recommends that you
hire or consult with a licensed and qualified
electrician or electrical contractor.
3.
Do not modify this product. Modifying or
mounting this product outside of the directions in
this installation guide will void the warranty and
may result in injury.
4.
Please adhere to Dry, Damp or Wet location use
restrictions. Wet location does not mean you can
‘submerge in water’. Do not install these products
within 5 feet of swimming pool or spa.
5.
Only install with GM Lighting LineDRIVE DC LED
Drivers. Using other drivers voids 5-year warranty.
6.
Some wattage profiles require installation into
GM Lighting LED mounting channels for proper heat
control.
7.
To avoid voltage drop, ensure that wire gauge
used is sufficient to keep under 3% voltage drop.
See Voltage Drop Chart on Page 7.
8.
Do not exceed maximum run listed for each
tape type, and for power supply (per circuit on dual
circuit models).
9.
Cut at designated cut points only (Fig. 1). Cutting
anywhere else will result in damage to the LED tape
and will void warranty.
10.
Do not solder. Use GM Lighting approved
SureTite™ or EZ connectors.
11.
Proper installation will insure many years of
successful usage. Failure to follow safety warnings
and instructions will void warranty.
90
C R I
+
12
VOLT
DIM
DRY
L O C A T I O N
FIELD
C U T T A B L E
20
IP
65
IP
WET
L O C A T I O N
24
VOLT
2
CLASS
24
TITLE
Only GM’s LineDRIVE power supplies offer
a 5-year product warranty for
both the driver and tape
when used
together!
Trim only on cut marks
FIG. 1
Do not exceed
80% load per circuit
on any power supply.
SEE WIRING DIAGRAMS
PAGE 8 and 9
