Glutz eAccess, Инструкция по эксплуатации

Страница: 17 / 40

- 17 -
f
The devices are already installed and connected to the mains or the batteries are inserted.
f
The devices have been tested during installation (signal given when batteries are inserted) and are
ready to use in FACTORY operating mode.
f
The SINGLE card set is complete and available on site.
3.1 Prerequisites
3.2 Initialisation
3.3 Reset
3 Commissioning in SINGLE operating mode
Application
After the initial commissioning, the device is switched from FACTORY operating mode to SINGLE oper-
ating mode so that only authorised persons (end users) can gain access.
Description
The initialisation process switches the operating mode from FACTORY to SINGLE. The system is then in
a secure mode. (The system can only be overwritten via a reset)
Card order:
Application
Should a reset be necessary, the device can easily put back into FACTORY operating mode.
Description
The reset puts everything back to FACTORY mode.
All recorded indentification media are deleted.
The device reverts back to FACTORY operating mode.
Card order:
123.456.789.0
123.456.789.0 123.456.789.0
123.456.789.0 123.456.789.0 1234.5678 123.456.789.0 1234.5678
123.456.789.0 1234.5678