Glue Machinery Corporation
Champ™ Stick 400 Manual
Part # G25E03-001
Glue Machinery Corporation™
4234 Boston St, Baltimore, Maryland 21224
Toll Free 1-888-202-2468 | Phone: 410-761-2727 | Fax: 410-761-5127 | Email:
www.gluemachinery.com
Preventive Maintenance
1.
To prevent the clogging of the glue gun, keep feeding mechanism and melt chamber free
from dirt and other foreign debris. Store unused glue sticks in a clean environment.
2.
Do not pull glue stick from the back of the glue gun. The feed mechanism may be damaged
or impaired. If you desire to change types of glue, cut off the protruding end and feed the
remainder through with the new type of glue.
3.
Do not lay heated gun on its side. Keep the heated gun in an upright position, on the metal
stand or workbench, with nozzle pointed down.
4.
If melted glue has escaped from the melt chamber entrance and is interfering with the feed
mechanism; allow gun to cool, and gently remove the obstructing glue.
5.
Replace the nozzle if glue drips excessively. Do not attempt to change nozzle when glue is
cold. To change, the gun must be heated until the glue is softened enough to remove nozzle
(about 1 minute). Use gloves and with a wrench, remove the old nozzle. Flush glue through
the gun, to clean out the melting chamber. Replace with a new nozzle. Tighten only until
snug. Do not over tighten.
6.
Keep outside of glue gun clean.
7.
Only
use
approved
11mm diameter stick glue with this gun
Champ™ Stick 400 Functions
Glue feeding direction
Stroke adjustor
Power input
ON/OFF switch
Trigger
Temperature adjustor
