R
R
R
-
-
-
G
G
G
-
-
-
B
B
B
GLP
German Light Products GmbH
(Manual Version 1.06) / from Software Version 1.09/0.3)
17
c) Standard Mode (Hold down the ENTER- button during power ON)
After switching on the fixture, the DMX start address will be set to [001]. All other settings
will remain unchanged.
Additional Display Indications
As a default you'll find the following additional information in the first row of the LCD display:
XX/X/XX
06 = 600Hz / 12 = 1200Hz
N = Normal Mode / C = Compressed Mode / H = High Res. Mode
N = Tilt normal / I = Tilt inverted
N = Pan normal / I = Pan inverted
5
5
Maintaining and Cleaning the
I
I
M
M
P
P
R
R
E
E
S
S
S
S
I
I
O
O
N
N
X
X
L
L
The
I
I
M
M
P
P
R
R
E
E
S
S
S
S
I
I
O
O
N
N
X
X
L
L is a low maintenance fixture. It is only necessary to clean the
air inlets and outlets as well as the optical LED lenses from time to time. For safe
operation it is absolutely essential that the fixture is kept clean and that dust, dirt and
smoke-fluid residues must not build up on, or within, the fixture. If they do, the
fixture's light output will be significantly reduced, and damages to the fixture may
occur. Regular cleaning will not only ensure the maximum light output, but will also
allow the fixture to operate reliably throughout its entire life.
A soft lint-free cloth moistened with any good glass cleaning fluid is recom-
mended. Under no circumstances should alcohol or solvents be used to clean
the fixture or its lenses!
5.1 Safety regulations
•
Disconnect the fixture from the mains power before commencing any maintenance
work!
•
Wait minimum 15 minutes after removing the power to allow the fixture to cool down.
5.2 Maintenance Intervals (rule-of-thumb)
The maintenance schedule of any given fixture depends on the installation environment. Hence
no specific guidelines can be given. The cleaning intervals given below are suggestions, based
on practical experience. We suggest that you start with these and develop your own
maintenance schedule as you see the fixtures performance in your specific environment.
Maintenance Task
Interval
How
Cleaning of LED lenses and
optical system
weekly
soft brush /lint-free cloth
