GLP Fusion MBL40, Руководство пользователя

Страница: 7 / 37

German Light Products® Safety
Fusion MBL40 User Manual Rev. A 7
●
Use minimum 14 AWG or 1.5 mm
2
power input and relay cables that are minimum 16 A-
rated and temperature-rated to suit the application. In the USA and Canada the cables
must be UL-listed, type SJT or equivalent. In the EU the cables must be type H05VV-F or
equivalent.
●
Do not connect devices to power in a chain if the total maximum current draw of all the
devices in the chain when added together will exceed the current rating of any cable
or connector used at any point in the chain. The supplied power input cable is rated as
follows:
-
US power cable: 16 A, 14 AWG, UL-listed, E304117, SJT, 4.9 ft.
-
EU power cable: 16 A, 1.5 mm², H07RN-F, 1.5 m.
Do not connect more than three (3) Fusion MBL40 fixtures to power in a chain at 100-120
V, 60 Hz.
Do not connect more than six (6) Fusion MBL40 fixtures to power in a chain at 200-240 V,
50 Hz.
●
The voltage and frequency at the Mains OUT socket are the same as the voltage and
frequency applied to the Mains IN socket. Only connect devices to the Mains Out socket
that accept this voltage and frequency.
●
Fusion MBL40 fixtures do not have a user-replaceable fuse. If you suspect that a fuse has
blown, disconnect the fixture from power and send it to a technician authorized by GLP
for repair.
Fire safety and protection from burns
●
Do not operate the fixture if the ambient temperature (Ta) exceeds 40° C / 104° F.
●
The surface of the fixture’s casing can reach up to 90° C / 194° F during operation. Avoid
contact by persons and materials. Do not install the fixture in a location where there is a
risk of accidental contact. Allow the fixture to cool for at least 20 minutes before
handling
●
Keep the fixture well away from flammable materials.
●
Keep all combustible materials (e.g. fabric, wood, paper) at least 0.2 m / 8 in. away from
the fixture.
●
Ensure that there is free and unobstructed airflow around the fixture.
●
Do not illuminate surfaces within 0.2 m / 8 in. of the fixture. The light output from the
fixture is powerful enough to cause burns or fire in illuminated objects at very close
range.
●
Do not place any optical components other than Fusion MBL40 accessories from GLP
onto the front of the fixture.
●
Do not stick filters, masks or other materials onto the fixture. Do not block the light output
in any way. The front surface becomes hot during operation and can melt or ignite
objects that are in contact with the surface. Ensure that the front surface Is clean and
unobstructed at all times in order to prevent a fire hazard and damage to the fixture.