GB
21
Keep proper footing and balance at all
times.
Warning:
Rotating cutting blades.
Do not reach into ejector funnel.
Warning:
Blades continue to re-
volve when switched off!
Check your fuse protection:
240 V:
16-A (slow blow);
400 V:
10-A (slow blow)
400V
(three-phase current model)
Check for correct phase sequence!
Direction of rotation must be to
the left (looking at the blade
plate).
If direction of rotation is to the right,
invert the phases at the surface-type
connector socket.
There are two line contact pins on a
swivel insulation piece on this con-
nector socket which is blocked by
means of a pressure block. If the
motor runs in the wrong direction,
the pressure block need merely be
pushed back with a screwdriver and
the insulation piece turned round.
This takes only a few seconds, and
the motor will then run in the right
direction. The phase sequence may
vary from one mains to another.
Elements of the
machine
1
Filling funnel
2
Feeding tube
3
Tool compartment
4
Tubular frame (lower part)
5
Wheels
6
ON -switch (green)
7
OFF-switch (red)
8
Main connection
9
Motor cover with motor
10
Upper part of housing
discharge cover
Protection of the
shredder
Carefully observe the following
recommendations to avoid dam-
age!
Do not remove or bridge the switch-
ing and safety devices!
If the cutting blades are blocked,
switch off the shredder immediately!
976 165-02_Innen:976 165-01_Innen 02.11.2010 11:12 Uhr Seite 21
