Glomstad Motor GM - 6140H, Инструкция по установке, эксплуатации и обслуживанию

Страница: 5 / 27

1
Installation/Operation & Maintenance Manual
GM - 6140H 2-POST LIFT
Chapter 1 DESCRIPTION OF THE
MACHINE
The electro-hydraulic 2-post lift is a fixed installation.
This means that it is anchored to the ground and
built for lifting and positioning automobiles and vans
at a certain height off the ground.
The lift consists of the following main parts:
◆
Fixed structure (posts);
◆
Moving units (car arms);
◆
Lifting units (hydraulic cyl power unit);
◆
Safety devices.
Fig. 1 illustrates the working areas reserved for use
by operators around the lift.
Fig. 1
◆
Command side: this side of the lift includes the
area reserved for operators to access the
control box.
◆
Service side: this is the opposite side of the
command side.
◆
Front side: the side with the short arms.
◆
Rear side: the side with the long arms.
Fig. 2 illustrates the various parts of the lift.
Fig. 2
1.1 FIXED STRUCTURE
The structure consists of:
◆
2 posts, (service (Fig. 2-1) and command (Fig.
2-10) side post) built with bent steel plate. The
base is welded to a drilled plate to be anchored
to the floor. The hydraulic power unit
(Fig. 2-7)
are attached to the command post. Inside each
post are the moving parts to lift the vehicles.
◆
The column set on the base.
1.2 MOVING UNITS
Each unit consists of:
◆
Both carriage (Fig. 2-3 and Fig. 2-6) built with
welded steel plate. It joints by chain (Fig. 2-2)
and the cable (Fig. 2-9) , and at the bottom to
the lift arms by means of pins.
◆
The carriage moves along the post, guided by
plastic sliding pads, located inside the post
itself.
◆
Two telescopic arms, one long and one short
(Fig. 2-4) , built with tubular steel with a pad at
each end that can be height adjusted to hold
the car and on the opposite side the carriage
connection hole.