Page 8
Operating Instructions
1. Add the appropriate pre set mixing ingredients into the bowl.
2. Lift completely up on the bowl lift lever until the bowl locks into position
(Fig. 8-1).
NOTE:
The mixer will not start if the bowl is in the lowered position.
NOTE:
The time display should be illuminated ( -- ). Check to se if the unit is plugged in.
If it is not illuminated press the stop button and refer to the troubleshooting section
of this manual.
This unit has one speed and two fixed times available for use: 1 Bag (40 second mix cycle)
and 2Bags (55 second mix cycle).
This mixer uses a precalculated mixing batch amount set by the purchasing establishment or the
corporate owner(s)/operators.
3. Select one of the “Bag” buttons to begin mixing.
Always STOP the mixer BEFORE changing the speed times! Failure to do so may
damage the gears or other parts and WILL void the warranty!
To change the speed time after mixing has already begun:
a. Press the red stop button once.
b. Choose the appropriate “bag” button to restart the mixer.
NOTE:
If the mixer shuts off during operation, verify the batch size and that ingredients or obstructions are not
jamming the agitator. If there is a jam, press stop, unplug the mixer, and remove the obstruction.
If there is not obstruction to the unit or agitator:
NOTE:
The mixer is equipped with a motor overload protection. If the mixer shuts off during operation, press
the stop button and verify/reduce the batch size, then press the overload reset button located on the back
of the mixer base.
4. Once the ingredients have been thoroughly mixed, the mixer will stop and beep indicating that the mixing cycle
is complete.
NOTE:
The mixer will automatically stop when the time on the timer has expired.
5. Lower the bowl by pushing the bowl lift lever backwards and down to its resting position.
6. Remove the agitator from the planetary shaft by lifting it upwards, then rotating it counterclockwise until it is
unlocked. Lower the agitator and remove from the planetary shaft.
7. Push each bowl clamp backwards to unlock the bowl from the bowl cradle.
8. Lift up slightly on the bowl so it clears the pins on the bowl cradle.
Fig. 8-1
