Page 7
Operating Instructions
TO AVOID SERIOUS PERSONAL INJURY:
•
DO NOT
operate the mixer before reading the instruction manual first.
•
ALWAYS
disconnect or unplug electrical power before cleaning, servicing, or adjusting any parts or
attachments.
•
ALWAYS
keep hands, hair, and clothing away from moving parts.
ATTACHING THE BOWL TO THE MIXER
NOTE:
Install the bowl BEFORE attaching the agitators.
1. Lower the bowl by pushing the bowl lift lever, backward and down, to its resting position.
2. Lift the bowl by the bowl handle and:
a. Slowly position the locking pin (located on the rear of the bowl) into the hole in the
middle rear of the cradle (Fig. 7-1).
b. Lower the bowl onto the pins located on either side of the bowl cradle.
3. Once the bowl is positioned on the cradle, secure the bowl by pulling both bowl clamps
forward until the bowl is locked tight (Fig. 7-2).
ATTACHING THE AGITATOR TO THE MIXER (i.e. the Hook)
NOTE:
It is easier to install the agitator prior to adding ingredients into the bowl.
1. Make sure the bowl is in the lowered position (Fig. 7-3).
2. Slide the agitator slowly upwards onto the planetary shaft, fitting the shaft pin through the
slot in the agitator (Fig. 7-4).
3. Rotate the agitator clockwise to secure it onto the planetary shaft (Fig. 7-5).
MIXING INGREDIENTS
This mixer uses a precalculated mixing batch amount set by the purchasing
establishment or the corporate owner(s)/operators. Overloading or not
following this chart will damage the mixer and void the warranty.
IMPORTANT: Make sure the mixer is stopped in the off position and
the timer reads ( -- ). (If needed, addition ingredients
can be added slowly from the side of the bowl while the
mixer is operating.)
NEVER REACH INTO THE BOWL WHILE THE AGITATOR IS MOVING.
Fig. 7-1
Fig. 7-2
Fig. 7-3
Fig. 7-4
Fig. 7-5
