Page 18
BE ALERT.
Slicer knife is exposed. Always be aware of the placement of your hands/fingers in
relationship to knife.
11. Reinstall the knife cover. Align the knife cover with the pins located at the bottom and one at the top of
the knife guard. The locator pin at the top of the knife ring guard must be set through the knife cover
and pressed into place. Once the knife cover hole is seated over the pin, lift the cover release lever
back to the up position to secure knife cover (Fig. 18-1).
12. Reinstall knife sharpener. Put knife sharpener at the top of slicer with knife
sharpener handle pointing down (Fig. 18-2).
NEVER
operate slicer without knife sharpener installed. Make sure it is in place and fully seated on
top of slicer before operating.
13. Put the cleaned and sanitized carriage back into operation (Fig. 18-3).
14. Tighten carriage release knob to secure carriage to slicer (Fig. 18-4).
15. Plug in power cord.
Note: When slicer is plugged in, the white POWER indicator light will illuminate.
Note: If knife cover is not secure the knife motor will not start and the display will show
‘’ATTENTION Knife Cover Removed Install Knife Cover.’’
Note: When carriage is not returned to operating position (to the left), the knife motor will not
start and display will show ‘’ATTENTION Carriage Tilted Secure Carriage to Start.’’
Note: If carriage release knob is not secure, slicing performance will be poor and excessive
noise could occur.
Figure 18-4
Figure 18-3
Cleaning & Sanitizing
Figure 18-2
Figure 18-1
