USER MANUAL
BEAT-MV/BEAT-2
Edition: January 2016
Revision: No. 1
MODE OF USE -
19
3.1.5 Fitting connection:
Connect the unit cable connectors in the fitting terminals to be jointed. The contact
surfaces of both the fitting’s terminals and the cable connectors must always be clean.
NOTE !
We advise you to always use adapters, even
though the connection to the fitting may be made
directly. Doing so, the cable terminals are
protected, do not wear out, burn, etc.
It is recommend refraining from electrofusion if the exterior temperature
is below -10
/
C or above +45
/
C.
3.1.6 Entering electrofusion data in the unit:
Ù
BEAT-MV/BEAT-2: Entering joint data without barcode: via the keyboard.
BEAT-2 only: Click one of the 4 arrows. The display will show the following screen:
BEAT-2 23
/
C
FUSION DATA?
Where 23
/
C corresponds to the ambient temperature
(informative).
Enter voltage. Press the
¨
and
§
arrows to move the cursor to a different field and the
©
and
ª
arrows to select the values.
FUSION DATA: 23ºC
VOLTAGE(Volt):
$
40.0
40.0 Volt by default.
The electrofusion voltage should be between 8 and 48 V.
Press START/VALIDATE to pass to the next screen.
Enter the time indicated by the fitting manufacturer, bearing in mind the correction given
according to the ambient temperature (according to the manufacturer). Press the
¨
and
§
arrows to move the cursor to a different field and the
©
and
ª
arrows to select the
values.
FUSION DATA: 23ºC
TIME(s):
$
000
“0000" by default.
Maximum permitted time of 5940 seconds (99 minutes).
Press START/VALIDATE to pass to the next screen.
SCRAPED & CLEANED ?
<YES>
Does not contemplate it being <NO>.
