USER MANUAL
BEAT-MV/BEAT-2
Edition: January 2016
- MODE OF USE
Revision: No. 1
18
3.1.4 Using the Barcode Reader (BEAT-2):
If you read the different data (operator’s ID, job ID, fittings, pipe, etc) by using optical
means (scanner), connect the reader device into the corresponding connector and put it
in front of the barcode data.
ATTENTION !
The scanner should be correctly setup. In case no data is captured by the
device, carry out the following barcode reading.
Software version
#
v. 1.23
Software version
$
v. 1.24
Laser scanner: When reading, the connected scanner emits a red laser line of a particular
length. To capture the barcode data, place the scanner so that the laser line coincides
longitudinally with the barcode. The distance will depend on the size of the barcode to
read. Once the scanner has been placed in position, the laser line will stop flashing and
remain fixed. When this happens, press any of the three buttons on the top of the
scanner.
Figure 9: Example of using the laser scanner
