Global Lift Rotational R-450A, Руководство пользователя

Страница: 28 / 49

Fixed Anchor Installation Instructions
R-450A & R-450R
1. Always wear safety goggles.
2.
Follow the drill manufacturer’s safety instructions.
3. Use only solid carbide-tipped bits meeting the ANSI B94-12
tip diameter (Use 5/8 dia drill bit).
4. Drill the hole perpendicular to the work surface. To assure
full holding power do not ream the hole or allow the drill
to wobble.
5. Drill the whole as deep as full length of anchor
(2” deep)
but not closer that two anchor diameters to the bottom
(opposite surface of the concrete).
6. Clean the hole using compressed air and a wired brush. A
clean hole is necessary for proper performance.
7. Drop anchor in hole and tap flush with surface (anchor can
be set flush with base material or sub-set)
8. Using setting tool; set the drop in with several sharp
hammer blows until expansion plug bottoms out in hole.
Setting tool shown
9. Position the fixture.
10. Insert bolt and tighten