background image

INSTALLATION OF FRONT GRILLE 

INSTALLATION OF FRONT GRILLE 

AND THERMOSTAT KNOB

AND THERMOSTAT KNOB

1. Fasten front cover to heater assembly using the (2) long screws supplied.

2. Fit the thermostat knob on to the thermostat shaft and push into place.

MAINTENANCE AND OPERATION

MAINTENANCE AND OPERATION

CAUTION: Heater must be installed properly before operation.

1. After heater assembly is complete, rotate the thermostat knob fully

counterclockwise. This is the minimum heat setting.

2. Turn the heater’s power supply switch to the “ON” position

NOTE: THE HEATER SHOULD NOT ACTUALLY TURN ON AT THIS POINT. IF HEATER
BEGINS OPERATION, TURN SWITCH OFF, DISCONNECT POWER SUPPLY AND
RECHECK WIRING.

3. Rotate thermostat knob fully clockwise to reach the maximum heat setting.

4. Wait at least 2 minutes, the fan control will not allow the fan to run until the

heating element is warm.

5. If fan does not come on after extended period of time, check to see if heating

element is on and check wiring.

6. Allow heater to continue operating until desired room temperature is reached,

then turn thermostat knob counterclockwise until thermostat clicks off. The fan
will continue operating until the element cools.

7. Readjust thermostat settings until room remains comfortable temperature.

Turning the thermostat clockwise will increase the duration of heat production
while turning it counterclockwise will decrease the duration.

NOTE: It is advised to leave the thermostat fully clockwise when heating room from
cold temperatures.

8. For continuous fan only operation (where the heting element remains off ), rotate

the thermostat knob so that the indicator on the knob points to “FAN”

NOTE: If the heating element is on and the heater is suddenly turned off, the fan
will continue to run to help the heating element cool until it reaches a low enough
temperature, at which point it will shut off.

CAUTION: Operation of the manual reset safety thermal limit control is an indication 
that the heater has been subjected to some abnormal condition, It is recommended 
that the heater be checked by a reputable electrician or repair service to ensure the 
heater has not been damaged.

6

Fan Forced Wall Heater

Содержание 246744








Отзывы: