34
Need help or have any questions? Call us at 1-714-963-0329 or send us an email to [email protected]
Step 4: Installing the Wheels
❑
Wrap one rubber band over the center of each plastic
wheel.
❑
Center each rubber band, then glue them to the wheels
using a couple of drops of thin C/A.
❑
Push one nylon wheel retainer into the molded hole in the center of each nylon main gear wheel.
❑
Push one wheel retainer/wheel assembly firmly onto the end of each landing gear axle.
❑
Using a pair of pliers, carefully bend each landing gear strut forward until the wheels are directly below the leading
edge of the wing.
❑
# 0 Phillips Head Screwdriver
❑
Excel Modeling Knife
YOU'LL NEED THE FOLLOWING PARTS:
❑
(1) Molded Clear Canopy
❑
(2) 2mm x 5mm Wood Screws
SECTION 13: CANOPY INSTALLATION
❑
(1) Decal Sheet
YOU'LL NEED THE FOLLOWING TOOLS AND SUPPLIES:
❑
Scissors
❑
220 Grit Sandpaper w/Sanding Block
Step 1: Cutting Out the Canopy
❑
Using a pair of scissors, cut out the black cockpit decal along its outer edges.
❑
Apply the decal to the cockpit, making sure to cut the decal out around the two wood screws that hold the radio tray.
☞
If the decal overhangs the cockpit area, trim the edges of the decal flush using a sharp modeling knife.
❑
Using a pair of scissors, cut out the clear canopy along
the molded scribe lines.
❑
Using 220 grit sandpaper with a sanding block, carefully
sand the edges of the canopy smooth and straight.
