Glion 510 B1, Руководство пользователя

Страница: 19 / 41

211026v1
3. While holding the seat in the desired position, use a 6 mm hex wrench to tighten the seat adjustment
bolt securely.
WARNING: Prior to first use, be sure to tighten the seat clamp via the seat adjustment bolt
properly. A loose seat clamp or seat post adjustment bolt can cause bike/property damage, loss
of control, a fall, serious injury or death. Periodically check to make sure that the seat clamp is properly
tightened.
ADJUSTING HANDLEBAR HEIGHT
1. Open the quick release lever by swinging the lever open and
outwards.
2. Move the handlebars up and down by sliding the handlebar post in or
out of the stem careful not to over extend the handlebar electrical
wires/brake cables.
Set the desired handlebar height.
3. After tightening the adjustment nut (opposite the quick release lever)
on the handlebar quick release clamp, properly close the quick release
lever fully as shown in the image on the right and the handlebar is secure
and cannot move up or down. Push down and pull up on the handlebar to
make sure it is secure.
FOLDING AND UNFOLDING THE FRAME
Folding the frame of Glion B1 Model 510:
1. Stand at the left side of the bike and ensure the cranks are parallel to the ground and the kickstand is
in the up position.
2. Push forward the silver knob located underneath the black latch of the
Two Step Frame Folding Mechanism (step 1) and then pull open the black
latch so that it is at least perpendicular to the frame (step 2).
3. Begin to fold until both sides of the frame are next to each other, turning
the front wheel slightly left to facilitate folding if needed. Rest the bike on
the frame stand under the cranks.
Helpful tip: While applying the front brake, press thigh against hinge to
slightly unfold the bike and walk the rear of the bike forward.
Unfolding the frame of the Glion Model 510: