Glidecam Smooth Shooter, Быстрая настройка

Страница: 22 / 33

22
Figure 25
In order to remove or install either of the SPRINGS in the SUPPORT ARM, you
must first make sure that the SLED is not on the end of the ARM and that the
ARM is not attached to the VEST. You must also make sure that the ARM is not
under load and that it is angled upwards. With the ARM angled upwards, you
can easily remove the ADJUSTER BOLT or BOLTS as shown in figures 23-25.
With both ADJUSTER BOLTS removed, you can now angle the SUPPORT ARM
downwards, thereby allowing you easy access to each SPRING’S RETAINING
BOLT as in figure 26.
NOTE: You will not be able to angle the SUPPORT ARM downwards if one of
the ADJUSTER BOLTS remains attached to the SPRING. Both ADJUSTER
BOLTS must be removed for the ARM to be angled downwards.