Glentek SMB9675-1A-1, Руководство по установке и эксплуатации

Страница: 3 / 36

TABLE OF CONTENTS
CHAPTER ONE: GENERAL
1.1 Overview……………………………………….…………………...3
1.2 Intended Application………………………….…………………...3
1.3 Equivalent GTK Vector Drive Replacement…….……. ………...4
1.4 Equivalent GTK VFD Drive Replacement……….……………...5
CHAPTER TWO: APPLICATION SOFTWARE
2.1 MotionMaestro©……………………………….…………………..6
2.2 Installing MotionMaestro©………………………..……………….6
2.2.1 Requirements………………………...………………...6
2.2.2 MotionMaestro© v1.37………………...……………...6
2.2.3 Installation………………………………...…………….6
2.3 Communicating with the Vector Drive……………….…………..7
2.3.1 Serial Port……………………………….……………...7
2.3.2 USB Port………………………………...……………...7
CHAPTER THREE:
INSTALLING THE GLENTEK VECTOR DRIVE INTO A FADAL VMC
3.1 Removing the old drive………………………….………………...8
3.2 Mechanical Installation…………………………….……………...8
3.3 Electrical Installation………………………………….…………...8
3.3.1 Power Terminal Block Connections……..…………...8
3.3.2 Load Meter Cable……………………………………...8
3.3.3 Control Cable…………………………..……………….8
3.3.4 Wye/Delta Cable…………………………..…………...8
3.3.5 Encoder Feedback Cable……………….…………….8
3.3.6 Rigid Tap Cable (Encoder Output)……….…………..8
CHAPTER FOUR: SETUP AND TUNING
4.1 Turning the power on………………………….…………………..10
4.2 Establishing Communications……………….…………………...10
4.3 Motor Parameters……………………………….………………….11
4.4 Tuning & Offset Adjustment……………………..………………..12
4.5 Saving Your Setup…………………………….…………………..12
4.6 Rigid Tap Test………………………………….…………………..13
CHAPTER FIVE: TROUBLESHOOTING AND MAINTENANCE
5.1 Status Display Codes………………..…………………………….15
5.2 Maintenance…………………………..…………………………….15
CHAPTER SIX: WARRANTY, FACTORY REPAIR AND SAFETY
6.1 Warranty……………………..……………………………………..16
6.2 Factory Repair…………..………………………………………….16
6.3 Safety…………………………..…………………………………...17
APPENDIX A - SERVO DRIVE CONNECTIONS
A - 1 Power, Regen, and Motor Connector………………………….18
A - 2 Controller I/O Connector………………..……………………...18
A - 3 Encoder Input Connector………………..……………………..19
A - 4 Encoder Ooutput Connector………………..………………….20
A - 5 Serial Communication Connector……..……………………….20
1
Fadal is a trademark of Fadal Machining Centers, we have no affiliation with Fadal or Mag IAS