Page
24
of
27
AES67 MODE
The Mix32 uses a module from Audinate called a Brooklyn Module for its network
audio interface. Audinate are the company behind Dante
®
and as such the module’s
primary network audio protocol is Dante
®
, however Audinate have enabled their
module to comply with AES67 and therefore the Mix32 can be set to AES67 mode
for interaction with other AES67 devices.
Please note however that Glensound are relying on Audinate’s AES67 interface and
are unfortunately not able to provide full AES67 support for the unit. AES67 support
should be sought directly from Audinate.
1. Turning On AES67 Mode
If you want to use your Mix32 on an AES67 network and it has not been set to
AES67 mode then this can be set in Dante controller by double clicking the Mix32 to
open the Device View window where you will find an AES67 tab to enable AES67
support.
Once the AES67 drop down box has been enabled you’ll have to reboot the Mix32
for the change to take effect. After the reboot go back to the AES67 tab and set the
multicast prefix address to one that is suitable for your newtork.
