Page
12
of
27
Running Dante Controller
At the time of writing this manual the Dante Controller looks as per the screenshot
below:
The Beatrice Mix32 will have been named at the factory during test to allow them to
be identified by the Dante controller.
The format used for the factory name is:
‘Mix32-10aa16-serial-102’
Where ‘Mix32-10aa16’ refers to the Glensound product i.e. Beatrice Mix32 and its
Dante Brooklyn module MAC address and ‘serial-102’ denotes the hardware racks
serial number.
Dante Controller Tip
If you have never run Dante controller before then make sure that on the bottom left
of the Dante controllers’ screen ‘P’ or ‘S’ is next to a green square as this indicates
that it is connected to a network. By clicking ‘P’ or ‘S’ a pop-up box opens to allow
you to set what network interface the controller is using.
