Glen Dimplex new world, Руководство пользователя и инструкция по установке

Страница: 11 / 20

INSTALLATION INSTRUCTIONS - DUAL FUEL
13.210
Fitting the plinth (if applicable)
• Ensure the appliance is raised to a height of 915mm or above using
adjusting feet (A) before beginning.
• Open the appliance doors and loosen screw (C), do not remove the screw entirely.
If your appliance has a storage drawer at the bottom, you access the screws
through holes located at the base of the drawer after lifting the mat.
• Fit plinth (B) and secure using screw (C).
DOOR
PLINTH
OVEN CAVITY
B
A
C
CONNECT TO THE ELECTRICITY SUPPLY
Warning: This appliance must be earthed.
The appliance must be installed by a competent electrician using a double pole
control unit of 32 ampere minimum capacity with 3mm minimum contact separation at
all poles.
We recommend that the appliance is connected by a qualified electrician who is a
member of the N.I.C.E.I.C. and who will comply with the I.E.E. and local regulation.
1. Access to the mains terminal is gained by opening the terminal block cover at the
rear of the appliance (use a small flat-bladed screwdriver).
2. Connection should be made with 6.0mm2 flexible twin and earth cable.
3. First strip the wires, then push the cable through the cable clamp in the terminal
block cover.
4. Connect the cable to the terminal block and tighten the cable clamp screw (see
diagram).
5. Close the terminal box, ensuring that the cover is engaged on the locking tabs.