Glen Dimplex new world, Руководство пользователя и инструкция по установке

Страница: 13 / 20

INSTALLATION INSTRUCTIONS - DUAL FUEL
13.210
into contact with a flexible connector have a temperature rise of less than 70°C.
After installation, make sure all connections are gas sound.
COMMISSIONING
Burner aeration
All burners have fixed aeration and no adjustment is possible.
Hob burner
Turn the control knob to the FULL ON position, wait a second before pressing the igni-
tion switch or holding a lighted match or taper to the burner. Hold the control knob in
for 15 seconds. Do not hold the control knob in for longer that 15 seconds. If the burner
fails to light within this time, release the control knob and wait one minute before at-
tempting further ignition.
CHECK THE OPERATION OF ELECTRICAL COMPONENTS
Clock Programmer/Minute Minder
Check functions as described earlier in this booklet.
Oven light & Convection fan
Open the main oven door. Turn the main oven control knob to the defrost setting
Check the oven light and convection fan both come on. Turn control knob back to off
( )
position.
Cooling Fan
Open the grill door. Turn the grill control knob to the full power setting . Check that
the cooling fan operates. Turn control knob back to off
( )
position and check cooling
fan switches off immediately.
Lid Safety system (if fitted)
Ignite all hotplate burners including wok. Attempt to close the lid and make sure all
flames are extinguished by the safety system.
If you are satisfied that the cooker is operating correctly, turn it off and show the
customer how to use it. Make sure you ask the customer to operate the clock (if fitted)
and controls.
Explain to the user that the lid safety system must not be used as a means of turning
off the hotplate burners. Control knobs must always be turned to the off position after
use.
Note: If the cooker does not perform correctly, inform the customer of the problem and
put a warning notice on the cooker. If the problem is dangerous, then disconnect the
cooker. If there is a fault, then the customer should be advised to contact the manufac-
turer’s local service organization or the retailer.
Before leaving the installation hand over the handbook to the customer