8
4) FIXING THE HOT PLATE
The hot plate has a special seal which prevents
liquid from infiltrating into the cabinet. Strictly comply
with the following instructions in order to correctly
apply this seal:
- Detach the seals from their backing, checking that
the transparent protection still adheres to the seal
itself.
- Overturn the hot plate and correctly position seal
“E” (fig. 9) on top of the upturned edge of the
hotplate flat with the outer side of the strip in line
with the external perimeter of the top, pay attention
not to sink the seal between the space bottom/top
rim.
- Evenly and securely fix the seal to the hot plate,
press into place with the fingers and remove the
strip of protective paper from the seal and set the
plate into the hole made in the cabinet.
- Fix the brackets as per fig.10.
- The prospective walls (left or right) that exceed the
working table in height must be at a minimum
distance from the cutting as mentioned both in the
columns and the scheme.
- If the appliance is installed so that the base can be
touched, a barrier must be installed to prevent
accidental contact with the base. This barrier shield
must be at least 60 mm below the surface of the
working top (fig. 7). Timber or other suitable
material may be used provided it is capable of
withstanding the appliance temperatures. Ensure
that the supply connection point is accessible with
the appliance installed. To facilitate the shield may
need to be removable.
IMPORTANT INFORMATION FOR THE
INSTALLER
When installing the device, the installer must use the
supplied fixing brackets according to the scheme
shown in picture 10. Therefore it is necessary to put
the bracket "S" into the slot "H" and tighten the
screw "F".
Be careful not to tighten too much, in order to
avoid the deformation of the bottom and the
malfunction of the device. In this case the
producer will not be considered responsible in
any way.
Viceversa, if the thickness of the top is thin, the
brackets can be used even in the opposite direction
(see picture 10/A), being careful to tighten the fixing
screw "F" moderately.
Even in case of deformation of the bottom
caused by the tightening, the manufacturer will
not be considered responsible in any way.
INSTALLATION
FIG. 9
FIG. 10
FIG. 10/A
