Glatz ALEXO, Инструкция по установке и эксплуатации

Страница: 12 / 27

23 22
Assembly and commissioning Use
2.2
2.3
2.4
1. Sunshade canopy in an upright
position
2. Unlock slider
3. Pull the slider downwards
4. Pull out / wrap fabric segments
5. Apply binding belt / ribbon
6. Apply protective cover if necessary
Close sunshade
2
Only wrap / pack completely dry
sunshades.
!
Instruction manual
Supporting struts
Gear joint /
Clamping screw
Base (optional)
Slider
1
Supplied with:
- Sunshade
- Tie-rope (material class 5)
- Operating instructions
Unpack the sunshade
Dispose of packaging materials properly
and keep away from children. Do not
install defective material. In case of dam-
age, please inform the transport service
provider immediately.
!
Put the sunshade together
2
2.1
2.2 2.3
1. Loosen the clamping screw sufficiently
2. Align the lower pole with the top pole
3. Tighten the clamping screw
4. Check that it is firmly attached
In order to avoid damages, do not
over-tighten the clamping screw.
!
Setting up the sunshade
3
1. Place sunshade in base
2. Tighten the base tube clamp
* maximum wind speed when it is securely anchored
in the ground.
Size
minimum
weight
maximum
wind speed*
[cm] [kg] [km/h (Bft.)]
ø200 30 20 (4)
ø220 30 20 (4)
3.1
3.2
1. Remove any protective cover
2. Release binding belt / ribbon
3. Pull the ribs outwards slightly
4. Slide the slider upwards
5. Slider engages audibly above
6. Hold moving part firmly
7. Sufficiently loosen the clamping screw
on the gear joint
8. Tilt sunshade
9. Tighten the clamping screw
Open sunshade / tilt the sunshade
canopy
1
The slider must engage audibly above.
When tilting the sunshade, hold the
moving part on the upper pole firmly.
!
Click
1.4
1.5
1.7
1.8
1.9