STEP 17
.
Install the “A” Vinyls
on the wall side of
each door. The “A” Vinyls ae supplied oversize and
should be measured against the glass and cut to size.
An “H” Vinyl is also supplied to be installed on the
inside edge of the Inner door to be used only if the
shower sprays into the gap between the doors.
STEP 18. Adjust the Door Stops:
Working from the inside of the
shower, bring both doors to the closed position where the Vinyls are
touching the walls on both sides. Move the Inner and Outer Stops into
the desired positions where the “A” Vinyls are just slightly compressed.
Tighten the screws for the door stops for this closed position.
Carefully
move the doors to the opposite ends of the header,
leave 1/2” to 1” gap
between this position and the wall and tighten
the second set of stops at this end of the header for both doors.
15
Detail 17A -- “A” Vinyl
Detail 17C -- Shows“A” Vinyl in place
Detail 18A — Shows Doors in closed Position
Detail 18B -- Shows Doors fully open with 1/2” gap to the wall
Detail 17B -- “H” Vinyl
Only use if needed as a splash
guard between the doors
Vinyls should be
touching the wall.
1/2” gap between
the glass door
and the wall.
Move the outer edge Stops to this
position and tighten in place.
Tighten both Inner and Outer Door
Stops on both doors at this poistion at
the the ends of the Header in to prevent
the glass doors from hitting the wall.
