11
STEP 12. Measure to Position the Curb Dam
Assemble the Curb Dam (as cut to size) with the Center
Guide. Slide the Center Guide under the Inner door. (Be
sure to align the Center Guide with the mark for the
screw hole). Be sure to use the marked
position of the Curb Dam following the pencil lines at
each end on the wall and across the outside edge of the
base. Tape into temporary position with duct tape. Test
the Inner door for smooth movement holding the
Center Guide in position.
STEP 13
. Lift out the parts and drill the hole for the Cen-
ter Guide. Insert a small amount of silicone and the An-
chor. Wipe the base clean of all debris. Clean surface
with denatured alcohol (Do Not remove the pencil
marks for the outside of the Curb Dam.)
Centerline
Pencil line for
Curb Dam
position
Position the Curb Dam
pencil mark for outside
edge 1 15/32” from the
center line.
Detail 12C— Section View
Detail 12D — Center Guide Detail
Detail 12B— Top view
Detail 12A
Mark the holes, drill and
install the anchor.
Shows the Curb
Dam within the
Center Guide with
Double Faced Tape
Guide Leaf
Inside view
