Glamox CT Series, Руководство пользователя

Страница: 38 / 48

38
8. Local variance.
If you desire a temperature setting perma-
nently at variance with that set by CT-, do
as follows:
Press in “F” and then while holding
“F” in. The display will now flash. Release
both keys.
Now press the or key once for each
°C you desire the variance to be (max.
+/– 5°C). If you are adjusting an already
set variance, the earlier variance will be
displayed.
The thermostat will complete the proce-
dure itself and after 15 seconds the flash -
ing will cease.
Example: The CT- remote control is
regulating several thermostats in different
rooms in the same zone with 22°C as the
desired room temperature. In one of the
rooms, this is experienced as a little cold.
You may then use the variance setting pro-
cedure and add e.g. 2°C. The thermostat
will then show 24°C even though CT- is
transmitting 22°C.
9. Central locking.
If, on attempting to operate, the thermostat
displays “--” for three seconds, it is locked
centrally at CT- to prevent tampering. May
only be cancelled at CT-.
10. Correcting the thermostat.
Correction (calibration) of the thermostat
must be carried out when the room is at
a stable temperature, i.e. when the red
lamp goes on and off at regular intervals.
If there is a deviation between the tem-
perature shown by the display and that
measured in the room, it may be corrected
as follows:
Press in “F” and then while still hold-
ing in “F”. The display will start to flash.
Release both keys. Correct the displayed
temperature to match room temperature
using the and keys. The thermostat
will complete the procedure itself and stop
flashing after about 15 seconds.
Example: The thermostat shows 22°C, but
a room thermometer shows 20°C. The ter-
mostat must here be adjusted down from
22°C to 20°C using the key.