4
HOMEDEPOT.COM/GLACIERBAY
Please contact 1-855-HD-GLACIER for further assistance.
1
Preparing for installation
Flange
Push
button
White
threaded
piece
Black
cable
Remove the old sink strainer and thoroughly clean off old putty
from around the sink opening (top and bottom).
Holding the metal flange, unscrew the long white threaded piece
from under the flange and let it slide down the cable.
Holding the black cable connected to the metal flange and push
button, unscrew the metal push button assembly and set aside.
Make sure the long white thread piece in the step above does not
get lost or broken.
NOTE:
If not already supplied in sink or counter top, suggested hole
diameter for push button mounted assembly is 1 inch.
2
Installing the basket strainer
Foam
washer
Rubber
Strainer
basket
Strainer
cup
washer
Remove the strainer basket from the strainer cup and set aside.
Separate the strainer cup from the strainer body by unscrewing
the bolt in the center of the cup. A screwdriver may need to be
used to loosen up the bolt if assembled too tight.
Apply a bead of plumer's putty around the underside of the
strainer cup flange.
Position the strainer cup in the sink opening and press down
firmly on all sides to compress putty.
From beneath the sink, slip the rubber and foam washers over
the strainer cup.
Align the strainer body with the strainer cup and re-connect the
cup to the body by threading the bolt into the center of the cup.
(This step may require two people.)
Tighten the center bolt with a screwdriver for a secure seal.
3
Installing the push button control
Rubbe
Push button
assembly
Mounting
nut
White
threaded
piece
Black
cable
r
washer
Choose the desired metal push button finish (chrome or stainless
steel). From underneath the sink, slide the black cable through
the opening and re-thread the metal push button assembly onto
the black cable. Make sure the rubber washer is on the underside
of the push button assembly (as shown in diagram).
From underneath the sink, connect the long white threaded
piece up through the opening and screw onto the push button
assembly.
Place the push button assembly and the white threaded piece
into the sink opening and screw the mounting nut from under-
neath the sink until the push button assembly is secured. Hand
tighten, plus 1/4 turn.
NOTE:
Do not use a wrench for the step above to avoid overtightening
and/or damage to the plasic pieces.
Installation
