9
Dispense Hot Water
This unit dispenses water at temperatures that can cause severe burns. Avoid direct
contact with hot water. Keep children and pets away from unit while dispensing. Never
allow children to dispense hot water without proper and direct supervision.
Note: After setup, hot water will be available in 15-20 minutes.
1. Position bottle, glass, pitcher or cooking pot securely below hot water tap.
• The left triangle below the hot water control indicates the location of the hot water tap.
• The circular shapes in the drip plate help align the flow of water. This unit dispenses water
at a fast rate. To avoid splashes, hold cup as close to the tap as possible.
2. Push hot water release button (red) inward and depress control downward to start flow.
3. Release control once desired fill level is achieved.
Replace an Empty Bottle
Notice: When your bottle is empty the water cooler will beep intermittently t
You may also hear a sucking sound when the bottle empties. This is normal and is another way
to be alerted that your bottle is empty.
Replace empty bottle as soon as you notice it is empty. If unavailable, leave door ajar or unplug
cooler to stop beeping noise and flashing lights.
There may be a small amount of water left in the bottle. This is normal, if you need assistance
please contact customer service.
1. Open door and slide bottle out.
2. Remove probe from bottle:
• Pull probe straight up until completely out of bottle.
• Hang probe on the door.
3. Install fresh bottle:
• Place fresh bottle in front of tray.
• Clean fresh bottle with a soft cloth and warm soapy water then wipe with clean wet cloth
• Remove entire plastic cap from top of bottle.
• Insert probe into bottle.
• Push down on probe until it is seated.
• Slide bottle onto tray and close door completely.
CAUTION
HOT WATER
