GJD GJD515, Руководство пользователя, Страница: 6 / 15

5. User interface
All settings are made through the web based user interface. This means there are no limits in hardware or software for using
the systems, all that is needed is a modern web browser.
The instructions for the user interface described below are valid for firmware 1.8.
5.1. Factory default settings
When using the system for the first time, or if a factory reset has been made, the following settings are used.
Product IP number 192.168.0.10
Subnet mask 255.255.255.0
Default router 192.168.0.1
Username admin
Password admin
5.2. Login
1. Open a web browser
2. In the address field, type in the selected unit IP-address.
3. The user interface login page is shown.
4. Login with your username and password.
5.3. Installation and configuration
5.3.1. Alignment
1. Open the Installation and configuration tab
2. The default sub-tab is the alignment window.
3. Turn on and off the alignment laser with the buttons. Remember to turn off the laser when the installation process is
complete.
4. Two diagrams shows live data from the sensor. The upper diagram shows data from the last 10 seconds and the second
data from the last 60 seconds. Each diagram has three curves, representing highest value (green), average value
(yellow) and lowest value (blue). This allows the diagram to display rapid changes accurately. It is also a good indication
of the signal stability. A remaining big difference between highest and lowest value indicates an unstable reference point,
such as tree branches etc.
5. To the right is a table with current distance, highest and lowest distance measured the last 60 second and current
weather intensity.
6