5.
Verify the metal sleeve is still on the 19mm bolt inside the shoulder.
Attach the new arm to the shoulder using the 17mm and 19mm bolts,
tightening both evenly.
6.
With the awning open about 18”, unband the high tension arm very carefully.
Slowly guide it into position on the lead rail and fasten it in place with the 5mm
allen head screw.
7.
Adjust the arms’ pitch angle to match the others by rotating the head of the
pitch-adjustment screw (Figure 13, screw A) as follows; rotate in a clockwise
direction to raise the arm, or rotate counterclockwise to lower it. Fully tighten
both lock nuts on the shoulder assembly. Please refer to the “ADJUSTING THE
PITCH ANGLE” section of this manual.
8.
The elbow height may need to be adjusted, using the 17mm and 19mm bolts
(Figure 11).
Page
46
of
49
Содержание GG750
