Girard Systems GG750, Руководство по обслуживанию и ремонту

Страница: 42 / 49

B. INSTALLING THE NEW MOTOR
1.
With the new motor in hand, align the notch in the drive (at the far end of the
motor)
with the indentation in the awning roller tube. Slide the motor all the way
in. Turn the motor until its inner notch also lines up with its indentation on the
tube.
2. Feed motor cable completely through the hole in the motor plate.
3.
Make sure the awning roller tube is still seated and connected into the roller tube
support bracket at the opposite end of the awning.
4.
Rotate the motor and roller tube assembly until the motor wire is
positioned towards the top of the awning.
5.
Reinstall the motor plate, lining the square motor peg up with the corresponding
slot. Reinstall the 3 screws securing the motor plate (Figure 17).
6.
Cut and strip the motor wires preparing for heat shrink butt connection, slide a
piece of heat shrink onto one end of the wires.
7.
8.
Connect the new motor wires with heat shrink butt connectors and heat shrink.
9.
Test for the proper function of the new motor by using the Remote Control or
the wall switch. NOTE: The motor limits are not adjusted yet, take care to
only test motor to make sure it is moving in each direction a small amount to
confirm.
10.
After the motor has been replaced, the motors’ limit switches must be adjusted.
Please refer to the “ADJUSTING MOTOR LIMIT SWITCHES” section of this
manual.
Replace motor side awning endcap with applicable screws.
Page
42
of
49