Page 8 of 12
SETUP AND PROGRAMMING
1.
Selection of “Continuous” or “Step” mode.
a.
Supply power to the GC154.
b.
Simultaneously press the STOP and RIGHT button of the GC154 for at least 6
seconds: The Green LED will first illuminate and then blink a few times. When
the Green LED extinguishes, the operation has been completed
To switch modes (continuous to step or step to continuous) repeat step 1
above.
NOTE:
•
Before starting this procedure the GC154 must be disconnected from all
power sources for at least 10 seconds.
•
During the programming procedure each step must be executed within 10
seconds of the preceding one.
2.
Programming the GC154 to a Remote handset or switch
a.
Supply power to the GC154
b.
Using a paper clip or other small tool, press the program button on the
GC154 (Fig 2) the Green LED will start blinking.
c.
Press STOP (Fig. 1): The Green LED will stop blinking and remain illuminated.
d.
Press the UP button on the REMOTE DEVICE being programmed. The Green
LED on the motor controller will turn off.
3.
Cancel one Remote from the GC154
a.
Supply power to the GC154
b.
Using a paper clip or other small tool, press the program button on the
GC154 (Fig 2) the Green LED will start blinking.
c.
Press STOP (Fig. 1): The Green LED will stop blinking and remain illuminated.
d.
Press the DOWN button on the REMOTE DEVICE being cancelled. The Green
LED will turn off.
4.
Cancel all of the Remotes from the GC154
a.
Supply power to the GC154
b.
Simultaneously press the STOP and LEFT button of the GC154 for at
least 6 seconds: The Green LED will first illuminate and then blink a few
times. When the Green LED extinguishes the operation has been
completed.
Содержание GC154
Страница 7: ...Page 7 of 12 ...
