Girard Systems GC154, Инструкция по эксплуатации

Страница: 12 / 12

Page 12 of 12
PROGRAMMING TO AN ANEMOMETER GC116I
Fully extend the awning to ensure smooth operation, and then retract the awning
leaving it partially open (about 3 feet).
Locate the P2 Button on the back of the motor controller.
Set the wind speed dial between 1 and 2 on the anemometer. (See Fig.1 above). The
higher this dial is set, the stronger the wind must be before the awning will retract.
Note; when carrying out this part of the procedure each step must be
executed within 10 seconds of the previous one or the module will revert to
factory settings. It is highly recommended that you read and understand the
following sequence before attempting to execute it.
1) Connect the Anemometer to a 12V DC Power source. (The Red LED will flash
once when power is connected)
2) Press the P2 button on the back of the motor controller (The green LED will start
to blink )
3) Press the STOP button on the motor controller (The green LED will stop blinking
and remain illuminated)
4) Press the up button on the Anemometer to retract the awning or physically
activate it by spinning the cups.
For queries or assistance with programming any of your G-Link devices please call
Girard Systems TOLL FREE on 800–382–8442 between 7:30am and 3:30pm P.S.T.
Wind Speed Dial P2 Button
UP Button LED