Girard Products G-1500, Руководство пользователя

Страница: 27 / 45

30 | P a g e
TROUBLESHOOTING GUIDE
Girard Systems recommends that all adjustments be made by authorized service
centers. The following guide is intended to help you become familiar with the awning in
case of emergency.
PROBLEM:
The lead rail is binding on the side of the awning casing; i.e. the rail is offset from housing.
SOLUTION:
Open the awning about 3 feet. Loosen the set screw on each arm at the point of connection to
the lead rail. Locate and remove the two fabric set screws that are on each end of the lead rail.
The lead rail is now ready to be shifted. Close the awning until the lead rail is about 4” away
from closing into the housing. Using a rubber mallet, tap the end of the lead rail to move it into
the correct position. When proper alignment has been achieved retighten the lead rail set
screws (Figure 20), then replace the fabric screws. (Figure 21)
(FIGURE 20) (FIGURE 21)
PROBLEM:
The motor side of the awning closes when the awning is retracted bot the opposite end does
not.
SOLUTION:
Refer to “Adjusting the Lead Rail” on page 23. If this does not solve the issue please call the
Girard Systems service line at (949)259-4000 or toll free at (800)382-8442.
Fabric set screw
Lead rail set screws