32
Assigning a flush-mounted home station to surface-mounted home
station video
A voice connection between two home stations
can be established via the internal call.
To assign a flush-mounted home station call but-
ton to the surface-mounted home station video,
please proceed as follows:
1. Press the "Systemprogr." button on the
control
device
for 3 sec. to start the programming
mode.
2. Press the call button on the
flush-mounted
home station
for 3 seconds. Release the call
button following the brief acknowledgement
tone sounds.
✓
The home station outputs a long acknowledge-
ment tone.
3. Press the button
on the
surface-mounted
home station video
for 3 seconds until a brief
acknowledgement tone is heard.
✓
A long acknowledgement tone indicates
successful assignment.
Three short acknowledgement tones indicate
faulty assignment. The memory of the surface-
mounted home station video may already be
occupied. A maximum of 24 call buttons can be
assigned.
4. Briefly press the "Systemprogr." button on the
control device
to exit the programming mode.
i
Releasing the button after 3 seconds
If the button is not released after the first
acknowledgement tone, all call buttons of the
home station will be deleted after an additional
3 seconds.
3s
3s
Hobbyraum
3s
1x