Gin Bolero 7, Руководство пользователя

Страница: 29 / 92

Bolero 7 user manual
_____________________________________________________________________________________________________________________________________
The Bolero 7 has various different high-quality and accurately manufactured lines which have been
selected according to the load and area of use. You should also protect the lines from unnecessary
UV light because, as with the fabric, UV light in particular will weaken the lines.
Dyneema lines, for example, are very temperature-sensitive and can be permanently damaged at
temperatures above 75° C. Therefore your glider should never be stored in a hot car especially during
summer.
Be careful that there is no abrasion caused to the coating on the lines by rubbing, particularly when
ground-training with crossed risers.
Do not walk on the lines after the glider has been spread out and watch out for spectators or skiers
who may inadvertently go over the lines.
When you are packing up the glider, be careful to avoid putting any unnecessary kinks in the lines
and use only the overhand knot or bowline knots described for the brake lines.
Various forms of plastic rods are used in the Bolero 7 (rigid construction), which help maintain the
shape of the leading edge and the stability of the canopy. To ensure that the plastic rods keep their
shape, it is important that you pack the glider as described in the section “Packing the paraglider”.
The plastic rods on the Bolero 7 can all be replaced through small pockets. If you notice that a
plastic rod has been damaged or misshapen because of incorrect use, this can be replaced by Gin
Gliders or a Gin Gliders authorised workshop.
If you do have to clean the glider, use only lukewarm fresh water and a soft sponge. Use a weak soap
solution for stubborn stains, and then rinse it out carefully and thoroughly. Leave the glider to dry in a
place which is well-ventilated and in the shade.
Do not under any circumstances use chemicals, brushes, rough cloths, high-pressure cleaners or
steamers to clean the glider, as these can damage the fabric coating and weaken it. The glider
becomes porous and loses breaking strength.
Do not under any circumstances put the glider in the washing machine. Even if washing powder is
not used, the glider would be badly damaged by the mechanical action of the machine. Do not put the
canopy into a swimming pool - chlorine will damage the fabric. If you have no choice but to rinse the
glider, e.g. following a landing in the sea, gently wash it down inside and out with fresh water.
Frequent rinsing accelerates the aging process.
Maintenance
GIN gliders have an exact identi fi cation on the underside of the wingtip or on the centre rib, which is
obligatory for all paragliders. The information required is set out in the airworthiness requirements.
It is helpful to provide the type designation of the paraglider if you are contacting your Gin Gliders
dealer with any queries or ordering replacement parts or accessories, to ensure accurate
identi
fi cation.
Page 29