6
battery is in low power status. Intermittent alarm will occur and the battery icon turns red in
the state of flashing.
High priority indicating that immediate operator response is required.
5.3. Accessories
A.
Dry battery(2AA)
B.
A User Manual
C.
A data line
D.
A disk (PC software)
E.
An adult-oximeter probe
An infant-oximeter probe
6. Operating Guide
6.1. Application method
A.
a)
Put the suitable probe into the jack on the right side of the oximeter. (The probe is limited to be
produced by our company; never replace it with the similar ones by other manufacturers).
b)
Put the finger into the probe.
c)
Press the "power on/off button" long , until the device turns on.
d)
Do not shake the finger and keep the patient in a stable state during the process.
e)
The data can be read directly from the screen on the measuring interface.
Fingernails and the luminescent tube should be on the same side.
If the alarm function is on, the device will provide medium-priority alarm signal when
probe or finger is out. Intermittent alarm will occur and the user interface presents "FINGER
OUT".
Medium priority indicating that prompt operator response is required.
B. Pause alarm:
a)
Alarm including the alarm of measure data's going beyond the limits, the alarm of low-voltage,
the alarm of probe or finger's out of position.
b)
When alarm is on, press the "alarm pause button" can pause the alarm, it can renew alarm in
about 60s, and if pressing the "alarm pause button" Again with in 60s, it can renew alarm .
c)
If you want to turn off the alarm for good, you should enter the menu for operation.
C. Review Interface
a)
On the measuring interface, press "up button" to enter the
Review Interface
1
directly, as
shown in figure 5:
