Care & Maintenance
Failure phenomenon
Analysis
Solution
Is the plug loose or poor contact?
After connecting the power
and pressing the “On/Off”
key, the appliance has no
response.
Use after resuming the electricity.
Is the plug socket connected well?
Is the automatic switch fuse in the home
short-circuited?
Check the root causes carefully. If the problem
cannot be fixed, please contact Service Centre
for checking and repairing.
Heating being interrupted in
normal use and a “Beep”
will be heard.
Incompatible cookware or no
cookware is used?
Replace compatible cookware for the
induction cooker.
Is the cookware not considerably
placed from the center of the heating
zone?
Place the cookware at the center of the defined
heating zone.
Is the cookware being heated but
continually being removed?
Place a cookware inside the heating zone.
No operation during the
heating being in use.
Is the cookware empty or the
temperature too high?
Please check whether the appliance is being
misused.
Is the air intake/exhaust vent clogged or
dirt has accumulated?
Remove the stuff clogging the air
intake/exhaust vent. Operate the appliance
again after cooled down.
Is the cooker working over 2 hours
without any external instruction?
Error codes occur
Reset cooking modes or use timer function.
(For ceramic zone)
Please contact service center for checking and
repairing.
When E3 or E4 occurs, pls switch off the
cooktop and use again after 10 minutes.
If other error code occurs, pls contact service
center for checking and repairing, please do
not repair it by yourself.
Error codes occur
(For induction zone)
E0- The fan short circuit
E1- The fan open circuit
E2- Sensor of PCB overheat
E3- Over-voltage
E4- Under-voltage
E5- Thermal couple open /short circuit
E6- Sensor of PCB open/short circuit
E7- Thermal couple overheat
E0- Internal circuit error
E1- No cookware or incompatible
cookware
E2- Internal overheat
E3- Over-voltage
E4- Under-voltage
E5- Top plate sensor open/short circuit
E6- IGBT sensor open/short circuit
E7- Top plate overheat
- Keep the heat vents clear
- The induction cooker may overheat or
damaged if bottom heat vents are blocked.
- Please do not place light table cloth/sheet
under the induction cooker when
using.Otherwise, heat vents may be blocked
by those materials.
- Thick table cloth or plastic plate are
suggested as replacement
。
- Please contact service centre for checking
and repairing.
During operations, if any error code occurred, please check the following table before calling for service.
Below are common errors and the check to perform.
安全注意事項
鍋具的選擇
操作方法
保養及清潔
規格參數
故障診斷方法
10
12
15
安裝說明
13
16
17
18
19
11
感謝你使用本產品，使用前請仔細閱讀本說明書，請妥善保存，以
便查閱。如發現任何問題，請直接與我們聯繫，我們將提供最好的服務。
E8- Power sharing failed
When E0, E2, E5-E8 erro code occurs.
