All specifications are subject to change without notice.
Copyright ©2019 Wilson & Gilkes. All rights reserved.
9. INSTRUCTION:
Operation of the eco-timer
5
1. The eco timer is located at the rear of the unit under the top
panel, access via the rear door.
2. Flip the Miniature Circuit Breaker (MCB) on the control box so
that the GREEN strip with the “OFF” print is visible.
3. Plug the trolley to the wall outlet, please ensure that the wall
outlet is not used for any other purpose or capable of supplying 10A
to the device without overloading the circuit and tripping the Circuit
breaker on the Switch Board consult an Electrician if unsure about
the load on that circuit.
4. Turn the switch on the wall outlet ON.
5. Trip the Miniature Circuit Breaker (MCB) on the timer control unit
so that the RED strip with the “ON” print is visible.
6. The LED light in the middle of the Start button shall flash few
times and becomes steady, unit is ready to start charging now.
7. Press the Start button to activate the timer, the LED will start
flashing regularly and will keep doing so until the end of set time by
the timer control unit.
8. Factory Default setting is 8hrs total charge time for all standard
timers, soft starts do not time out, please ask about other program
options at the time of ordering.
9. Timer units shall activate the powerboards one board at a time
and will have one minute delay between boards to avoid the
overload of the circuit due to a sudden start up load coming from
multiple units plugged into one powerpoint, at the end of eight
hours the unit will turn off automatically and the LED light will stop
flashing, stay steady instead.
10. To re-start the charging cycle, first switch power off at GPO,
after one minute, switch power back on and press the start button.
1.
Gilkon Eco Timer V3.0
