Gilera Nordwest, Руководство по ремонту

Страница: 116 / 136

WORKING PROCEDURES
All the plastic plugs are fitted with blocking tongues that must be released
before removing the plugs and aligned when the plugs are re-connected.
In order to isolate an electrical problem, always check the continuity in
the current path.
A continuity check is usually executed without removing the component
from the motorcycle; simply disconnect the wires and connect them to a
tester connector or ohmmeter.
INSTRUMENTS
Remove the fairing and headlamp.
Disconnect the tachometer cable.
Disconnect the speedometer cable.
Remove the instruments mounting nuts.
Disconnect the instruments connector wires (fig. 1).
Remove the bulb sockets and replace the burned bulbs.
Remount the instrumentation in reverse order of disassembly.
HEADLAMP
Remove the fairing mounting bolts.
Remove the headlamp fairing, optic group and disconnect the bulb wires.
Remove the bulb cover and replace if necessary (fig. 2)
Remove the bulb holder with the “TOP” marking facing up.
Connect the wires to the bulbs.
Install the headlamp and fairing and fasten with its mounting bolts.
Adjust the position of the headlamp.
TAIL LAMP
Remove the rear lens cover screws.
Replace with new bulb if necessary (fig. 3).
Install rear lens cover.
TURN SIGNAL INDICATORS
Remove the turn indicator lens cover.
Replace bulb if necessary.
Install turn indicator lens cover.
NEUTRAL SWITCH
Disconnect the neutral switch connector.
Check for continuity between the wire and ground for each gear
selection.
The switch is working properly when there is continuity in the neutral
position and no continuity in any other gear.
19 - 1,1