Introduction
Page 2
MDE-4017G Mat Reader Assembly Kit (C00016-XXX) Installation Manual · April 2017
Under IC regulations, this radio transmitter may only operate using an antenna of a type and
maximum (or lesser) gain approved for the transmitter by IC. To reduce potential radio
interference to other users, the antenna type and its gain should be so chosen that the
equivalent isotropically radiated power (e.i.r.p.) is not more than that necessary for successful
communication.
Conformément à la réglementation d’Industrie Canada, le présent émetteur radio peut
fonctionner avec une antenne d’un type et d’un gain maximal (ou inférieur) approuvé pour
l’émetteur par Industrie Canada. Dans le but de réduire les risques de brouillage
radioélectrique à l’intention des autres utilisateurs, il faut choisir le type d’antenne et son gain
de sorte que la puissance isotrope rayonnée équivalente (p.i.r.e.) ne dépasse pas l’intensité
nécessaire à l’établissement d’une communication satisfaisante.
Note: To ensure compliance with Electromagnetic Compatibility (EMC) standards, do not
remove the ferrite beads from the cable assemblies provided with them.
Required Tools
Following tools are required to install the Mat Reader Kit:
• Drill Motor and Bits
• Needle Nose Pliers
• Phillips
®
Screwdriver
• Zircon
®
Stud/Bracket Finder
• Key Fob (Security Hardware Device for Authentication)
Parts Lists
Following table lists the parts included in the C00016-010 Kit - Low Frequency (Mini Mat):
Item#
Description
Part Number
Quantity
1
Assembly, Interface Box, Mat Reader
M01814A001
1
2
Connector, Cover
M02498B001
1
3
Cable, Mat Reader Drive
M01872A002
1
4
Transient Suppressor, Magnetically Coupled
Q11433-107
2
5
Power Supply, Wall-mount
M01878B001
1
6
Jumper (.100 centers)
Q11011-01
1
7
Cable, Work Area
Q13850-06
1
8
Clamp, Releasable, Flat Cable Mounting
Q13459-01
3
9
Screw, Thread Forming, Hex Washer Head
K85736-06
2
10
Label, Customer Die Cut
N23290-02
1
Note: For component additions to this kit, refer to
“Additions to Mat Reader Kits”
