MDE-4017G Mat Reader Assembly Kit (C00016-XXX) Installation Manual · April 2017
Page 17
Installing Mat Reader Assembly
3
Set the jump jacks as follows (see
on
A properly grounded ESD wrist strap must be worn while servicing any electronic devices or
components. Failure to use electrostatic precautions may damage electronic components
and void warranty.
CAUTION
Following are the baud rate settings:
Mat Reader Baud Rates
Baud Rate (see Note)
BAUD 1
BAUD 2
BAUD 4
4800
OUT
OUT
OUT
2400
IN
OUT
OUT
1200
OUT
IN
OUT
300
IN
IN
OUT
38400
OUT
OUT
IN
19200
IN
OUT
IN
9600
OUT
IN
IN
4800
IN
IN
IN
Note: 4800 is the default Mat Reader Value.
4
If you are
NOT
daisy chaining the mat reader interface boxes, reinstall the cover removed in
step
.
Note: Daisy chaining is connecting the output from one interface box to the input of another
and the address of the second mat reader must match address on the first mat reader.
5
If you
ARE
daisy chaining the mat reader interface boxes, go to
to set addresses on the logic board.
Mounting and Connecting Mat Reader Interface Box
To mount and connect the mat reader interface box, proceed as follows:
1
Mount the mat reader interface box following the procedures in
2
Run both the power and data cables to the port end of the mat reader interface box
(see
on
) as follows:
a
Connect the J3 end of the Ribbon Cable (M01872A001) to the Interface P3 port.
b
Connect the P1 end of the Work Area Cable (Q13850-06) to the J1IN port. The other end
will be connected later.
