Gigabyte G262-IR0, Руководство пользователя

Страница: 24 / 99

- 26 -
System Hardware Installation
3-4 Installing the CPU
Read the following guidelines before you begin to install the CPU:
• • Make sure that the motherboard supports the CPU.
• • Always turn off the computer and unplug the power cord from the power outlet before installing
the CPU to prevent hardware damage.
• • Unplug all cables from the power outlets.
• • Disconnect all telecommunication cables from their ports.
•
• Place the system unit on a flat and stable surface.
• • Open the system according to the instructions.
• WARNING!
Failure to properly turn off the server before you start installing components may cause seri-
ous damage. Do not attempt the procedures described in the following sections unless you
are a qualified service technician.
• • To tighten the CPU cover screws, use T30-Lobe driver to tighten 4 captive nuts in sequence as
1-4.
• • The screw tightening torque: 8 ± 1.2 kgf-cm (17.0± 1.0 lbf-in)
Follow these instructions to install the CPU:
1. Align and install the processor on the carrier.
NOTE: Apply thermal compound evenly on the top of the CPU. Remove the protective cover from
the underside of the heat sink.
2. Carefully flip the heatsink over. Then install the carrier assembly on the bottom of the heatsink and
make sure the gold arrow is located in the correct direction.
3. Remove the CPU cover.
NOTE: Save the CPU cover in the event that you need to remove the CPU from the socket.
4. Align the heatsink with the CPU socket by the guide pins and make sure the gold arrow is located in
the correct direction. Then place the heatsink onto the top of the CPU socket.
5. To secure the heatsink, tighten the screws in a sequential order (1g2g3g4).
NOTE: When dissembling the heatsink, loosen the screws in reverse order (4g3g2g1).
1
2
3