Apollo
LIGHT
*,)$6 (/(&75,& *PE+ 3HEHULQJ6WUD $ (XJHQGRUI E 6DO]EXUJ 7 ) 'Z ZZZJLIDVDW
Startup Procedure / Pre -Start Checks
Remove the protective case from the shipping carton and correctly dispose of all packing
materials.
Remove all parts from the protective case and check the contents against the enclosed
packing list.
Ensure that all packing materials have been removed from the air inlet to the
cooling fan.
Positioning the Stand (see photo 1, page 8)
Open the locking nut (A) located at the base of the stand
Slide the collar down until all three supporting legs have been fully extended then re-lock
nut (A).
The operation is easier with the stand columns folded.
The stand incorporates one adjustable length leg to compensate for differences in ground
level or step.
To adjust carry out the following steps:
RSHQORFNLQJVFUHZ%
H[WHQGWKHOHJXQWLOWKHVWDQGUHDFKHVWKHYHUWLFDOSRVLWLRQ
ORFNLQJDJDLQVFUHZ%
It is essential that the stand is levelled BEFORE loading it with eqipment.
Mounting the ApolloLIGHT onto the stand
The stand is only to be used for the purpose of supporting the ApolloLIGHT. No other
equipment is to be secured to the stand.
The ApolloLIGHT is only to be used with this stand. No other stand is to be used with the
ApolloLIGHT.
Remove the ApolloLIGHT form the protecive case and mount it on top of the stand by
inserting the centre pole of the stand insiede of the neck of the ApolloLIGHT.
Make the electrical connection using the right angled plug on the ApolloLIGHT and a
suitable mains connector.
Set the output switch to either of the 2 following positions:
3RVLWLRQ
FRYHUDJH DSSUR[:
3RVLWLRQ
FRYHUDJH DSSUR[:
