Giersch MG20-ZM-L-LN Series, Руководство по установке

Страница: 19 / 32

Subject to alterations, 03.06.20 19/32
Start-up and calibration
LMV phase display
Display Description
Ph00 Fault phase
Ph01 Safety phase
Ph10 Go home
Ph12 Standby (stationary)
Ph22 Blower start-up time (blower motor = ON, safety valve = ON)
Ph24 Run in pre-air position
Ph30 Pre-air time
Ph36 Run in ignition position
Ph38 Pre-ignition phase
Ph39 Leakage check filling time (test pressure switch min for installation between fuel valve 1 and
fuel valve 2)
Ph40 First safety time (ignition transformer ON)
Ph42 First safety time (ignition transformer OFF)
Ph44 Interval 1
Ph50 Second safety time
Ph52 Interval 2
Ph60 Operation 1 (stationary)
Ph62 Maximum time small-load setting (operation 2, preparation decommissioning, run in small-load
setting)
Ph70 After-burn time
Ph72 Run in post-ventilation position
PH74 Post-ventilation time (no external leak test)
Ph78 Post-ventilation time (abort when power controller ON)
Ph80 Leakage check idle time
Ph81 Leakage check test time atmospheric pressure, atmosphere test
Ph82 Leakage check filling test, filling
Ph83 Leakage check test time gas pressure, pressure test
Ph90 Gas shortage waiting time