2
safety rules regarding outdoor power equipment (cont.)
• Belts and belt guard components are subject to
wear, damage, and deterioration, which could
expose moving parts or allow objects to be thrown.
Frequently check components and replace with
manufacturer’s recommended parts, when
necessary.
• Check operation of brake, tail and license lights
frequently. replace as required.
• Use only factory authorized replacement parts
when making repairs.
• Always comply with factory specifications on all
settings and adjustments.
• Only authorized service locations should be
utilized for major service and repair requirements.
• Never attempt to make major repairs on this unit
unless you have been properly trained. Improper
service procedures can result in hazardous
operation, equipment damage and voiding of
manufacturer’s warranty.
3
unit assembly & set-up
Note: Please refer to Parts List for correct part identification and placement. Parts list reference
numbers are called out by sheet number followed by reference number(s) on that sheet: (1:1) indicates
Sheet 1, reference number 1; (2:32,34-38) indicates Sheet 2, reference numbers 32 through 38 excluding
33; etc.
FENDER ASSEMBLY (CHW UNITS ONLY)
•
Insert one 3/8-16 x 1” bolt, fitted with one 3/8”
flat washer, out through the three fender
mounting holes (two located in the diagonal
brace, one in the support leg channel).
•
Attach fenders to sides of base, making sure
taillamp mounting brackets are toward rear of
unit as shown.
•
Secure each fender with flat washers, 3/8” split
lock washers, and 3/8-16 hex nuts. Tighten
securely.
•
Install one Taillamp assembly into the taillamp
mounting bracket of each fender, first by
inserting the rubber grommet into the bracket
hole, then pressing the taillamp firmly into the
grommet. (Taillamp wiring will be addressed
later.)
