Copyright © Gianni Industries, Inc. All rights reserved.
P-MU-DG-800 Ver. B Published: 2010.11.22
Page: - 6 -/ 8
5. Clearing Memory of All Proximity Cards and PINs
1.
Enter programming mode
2.
Press
＊
8 (Right Yellow LED rapid flash)
3.
Press 88 (Right Yellow LED stay on, 1 long beep)
4.
Press # (1 beep , Right Green LED stay on) back to standby mode
6. Resetting Controller Parameter to Default Value
1.
Enter programming mode
2.
Enter
＊
8 (Right Yellow LED rapid flash)
3.
Enter 99 (Both left & right Yellow LED stay on, 1 beep)
4.
Press # (1 beep , Right Green LED stay on) back to standby mode
7. Adding a Proximity Card and PIN to Relay 1
a.
1.
Enter programming mode to select slot position 000~999 (Left Green
LED stay on, Right Yellow LED rapid flash to indicate the slot position is
available)
2.
Read new card (1 beep), then press 5-digit PIN 99999(1 beep, Right
Yellow LED stay on).
3.
Press # (1 beep Right Green LED stay on) back to standby mode
NOTE: Master codes must NOT be the same as PIN codes.
b.
1.
Enter programming mode to select slot position 000~999 (Left Red
LED stay on, Right Yellow LED rapid flash to indicate the slot position
is unavailable)
2.
Press
＊＊
(1 beep), delete the data from the slot position (Left Green
LED stay on, Right Yellow LED rapid flash)
3.
Repeat the steps of 7-a to add new card.
8. Adding a Proximity Card and PIN to Relay 2
