GHM HONSBERG OMNIPLUS-F Series, Руководство по эксплуатации

Страница: 8 / 45

2 | Safety OMNIPLUS-F
8/ 45
C-E01_X__OMNIPLUS-F__DB2-1.0
2.4
Intended use
For reasons of safety and warranty, only personnel authorized by the manufacturer
may carry out interventions beyond those described in the operating instructions.
Unauthorized alterations or modifications are explicitly prohibited.
If used improperly or not as intended, this product may present application-specific
hazards.
The products are generally used for measuring and monitoring the volume flow in
pipelines. A number of different sensor forms are available for this purpose, which al-
low adaptation to different installation situations. The suitability of the sensor for media
other than water and the operating conditions must be ensured by the operator, in
compliance with the technical limits specified in the data sheet.
This product is intended for use in machines and systems and for the use of media of
fluid group II according to directive 2014/68/EU. Specified technical limit values ac-
cording to the respective valid product data sheet must not be exceeded.
2.5
Qualified personnel
For commissioning, operation and maintenance, the personnel concerned must have
a sufficient level of knowledge of the measurement procedure and the significance of
the measured values. This document makes a valuable contribution to this. The in-
structions in this document must be understood, observed and followed.
To ensure that no risks arise from the interpretation of the measured values in the ac-
tual application, the user should obtain further expertise in case of doubt. The user is
liable for damage/hazards resulting from misinterpretation due to insufficient expertise.
This document contains the information required for the intended use of the product
described therein. It is intended for technically qualified personnel who have been spe-
cially trained or have relevant knowledge in the field of automation technology or
measurement and control technology. Knowledge and technically correct implementa-
tion of the safety instructions and warnings contained in these instructions are prereq-
uisites for safe assembly, installation and commissioning as well as for safety during
operation of the device described.
Only qualified personnel have the necessary expertise to correctly interpret the safety
instructions and warnings used in these instructions in specific individual cases and to
put them into practice.
2.6 Standards
OMNIPLUS-F complies with the following standards and directives
Harmonized standards:
DIN EN 61326-1: 2013 General EMC requirements
DIN EN 61326-2-3:2013 Special EMC requirements
EN IEC 6300:2019 Restriction of hazardous substances
Guidelines:
2014/30/EU EMC Directive
2011/65/EU RoHS
2015/863/EU RoHS
1907/2006/EU REACH