www.ghibliwirbel.com
Professional Cleaning Machines Since 1968
EN
- 18
drain hose.
- Reassemble all of the parts by perform-
ing these operations in the opposite or-
der.
- Remove and clean the suction filter (59)
with running water, removing possible
pieces of paper, wood etc... which ob-
struct it.
12.1.c - Cleaning the wiper (Fig. 17)
In order to clean the squeegee correctly (20),
it is necessary to remove it as follows:
- Disconnect the hose (16) from the squee-
gee (20).
- Loosen the knobs (36) and remove the
squeegee (20).
- Wash the squeegee and in particular the
rubber blades (60) and the inside of the
aspiration connector (56).
NOTE:
If, during washing, it is clear that the rubber
blades (
60
) are damaged or worn, it is neces
-
sary to replace them or turn them over.
- Replace all the components in reverse
order.
12.1.d - Cleaning the side skirts (Fig.
18)
To make a proper cleaning of side skirts
(61) lift and wash the gums (62).
NOTE:
If, during washing, it is clear that the rubber
blades (62) are damaged or worn, it is neces
-
sary to replace them or turn them over.
- Lower the side skirt (61).
DANGER:
Do not lift the side skirts with the casing
(63) removed.
OPERATIONS TO BE
PERFORMED EVERY
3 MONTHS
12.1.e - Check the wear status of the
steering chain (Fig. 19)
- Check the wear and corrosion status of
the chain (66) found beneath the ma-
chine near the front wheel.
If the chain appears corroded, it must be
replaced.
Contact the technical assistance service.
OPERATIONS TO
PERFORM WHEN
NECESSARY
12.1.f - Replacing the brushes
(Fig. 20)
The brushes must be replaced whenever
they appear worn or whenever their bristles
are shorter than 2 cm. They must also be
replaced based on the type of flooring to be
cleaned; in order to replace them, perform
the following operations:
- Insert a hand beneath the brush support
unit (19). In order to detach the brush,
turn it quickly and forcefully in the oppo-
site direction from that in which it rotates
during normal function.
- Place the new brushes beneath the brush
support unit (19).
- Get into the driver’s seat and turn the key
(29 Fig. 9) to its “
ON
” position.
- Engage a movement direction.
- Press the “
ON/OFF
” (43 Fig. 9) button to en-
able brush rotation; the brush unit will be
lowered.
- By pressing the accelerator pedal (7 Fig.
10), the brush support flanges begin to
turn, thereby connecting with the brush-
es. Then, release the pedal.
- Press the “
ON/OFF
” (43 Fig. 9) button again
and turn the key (29 Fig. 9) to its “
OFF
”
position.
00_Manu_RUNNER_1ed 10-2020 - 49029500.indb 18
00_Manu_RUNNER_1ed 10-2020 - 49029500.indb 18
16/10/2020 08:15:40
16/10/2020 08:15:40
